Install a Heatmap on Your Site with Zoho PageSense
If you’re redesigning your website based on “I feel like people click this”… we need evidence. Let’s install a heatmap.
Zoho PageSense lets you track what visitors actually do on a page, including where they click, how far they scroll, and where they spend time. PageSense heatmaps include a click map, scroll map, and attention map so you can stop guessing and start optimizing.
This walkthrough matches the setup from your video and stays beginner-friendly.
Watch How to See Exactly Where Visitors Click on Your Website
What you will set up in under 2 minutes
- Install the Zoho PageSense snippet on your website pages
- Create a heatmap for a specific URL
- Let data collect, then read the report for patterns and problems
Step 1: Install the Zoho PageSense snippet code
Zoho PageSense tracking starts with installing a snippet on the pages you want to measure. Zoho’s guidance is to copy the snippet from the Snippet section in PageSense, then paste it into your website code.
Manual install steps
- Open Zoho PageSense
- Go to the Snippet section
- Copy your project snippet code and choose synchronous or asynchronous if prompted
- Paste the snippet right below the <head> tag on the pages you want to track
- Save and publish your website changes
Tip on snippet choice: Zoho notes that an asynchronous snippet is designed to avoid impacting page load, while synchronous or some tag manager approaches can affect load time.
If you use Zoho Sites
Zoho Sites has a direct integration path in the Sites editor under Integrations, where you can connect PageSense and publish your site for the integration to work.
Step 2: Create a heatmap for click tracking
Once the snippet is installed on the page, you can create a heatmap for that URL in PageSense.
- In PageSense, go to Heatmaps
- Click Create or New Heatmap
- Enter the URL you want to track
- Confirm the snippet is installed on that URL
- Start the heatmap
What you get from PageSense heatmaps
PageSense heatmaps include:
- Click map: where visitors click
- Scroll map: how far visitors scroll
- Attention map: where visitors spend time
Step 3: Let data collect and read the report like an optimizer
Heatmaps need traffic to show patterns. Let it run until you have enough visits to see consistent behavior, then review the report.
Here are the three fastest insights to look for:
1. Dead clicks
Visitors clicking things that are not clickable is a design signal. It often means:
- Something looks like a button but is not
- A section reads like a link but is plain text
- People are trying to navigate but cannot
2. CTAs getting ignored
If your call to action exists but gets low click density, consider:
- Moving it higher on the page
- Making the CTA more visually obvious
- Tightening the headline so the CTA feels relevant
3. Important content below the scroll drop-off
If most visitors do not scroll far enough to see your pricing, proof, or CTA, the fix is usually layout, not copy. Move the critical block up, shorten the page, or add a mid-page CTA.
Best practice: start with your highest value pages
If you are not sure where to begin, install and run heatmaps on:
- Your homepage
- Your primary service page
- Your booking or contact page
- Any landing page you send ads or social traffic to
That is where click tracking pays off fastest.
Wrap-up
Heatmaps are how you stop guessing and start optimizing like a grown-up business.
Install the snippet, start a heatmap on a real money page, then look for dead clicks, ignored CTAs, and scroll drop-off. Those three insights alone can change your site results without a redesign.
